| Testing and measuring machinery
for the automotive industry |
|
 |
 |
Durability test bench for
rack and pinion steering gears
|
| This test bench is used to
carry out durability tests of manual and power-assisted rack and pinion
steering gears. Static and dynamic tests up to 30 Hz tie rod load run
computer-controlled. The drive unit can be adjusted in 4 axes, the load
input unit in 2 axes. By TCP/IP interface, the status of the current tests
can be queried by any computer concerned. | |
Steering assembly machines
for truck steering gears
|
| The steering assembly
machines are used for type-dependent bolting of housing covers, measurement
of axial play and presetting of the frictional torque on commercial vehicle
steering gears in the assembly line. Automatic identification of the
steering gear types enables types to be changed without manual intervention. | |
|
|
 |
 |
Production facility for
ornamental and facing rings
Producing rings off the conveyor belt - is that your problem?
The manufacture of ornamental and facing rings from various materials for a
wide variety of applications:
case rings for timepieces, ornamental and facing rings for pressure gauges
and other instruments, protective rims for cooking pots, ball bearing cages,
cooker hotplate rings etc. This has certainly caused many a headache,
because the production of the rings must keep in step with that of the
products they are used for. | |
Semi-Automatic Facility
for producing ornamental and facing rings
The manufacture of high-quality yet inexpensive ornamental and facing rings
for the pot and fitting industry and for other applications presented us
with the problem of finding another solution in addition to the fully
automatic facility we already produce. The machine had to be on a much lower
technical level to permit an initial start to ring production with
approximately equivalent quality. It was accepted here that the quality of
the rings would partly depend on the skill of the operator. The facility was
to be operable by one or two persons. |
|
|
|
 |
 |
Gearbox test stand
Test stand serves to discover and test control characteristic of automatic
transmissions with hydraulic and electronic control.Test is carried out
with steplessly variable automatic transmissions as well as with automatic
multi-step transmissions for front and rear drive and with special-type
transmissions. | |
Durability test bench for
axial joints
|
| The axial joint test bench
subjects different axial joints to severe single and continuous load tests.
Duty cycles, angular movements, temperature and air humidity can be
preselected freely. Failure criterion is the axial play that develops or the
breakage of the axial joint. |
|
C 
