24/7 Service Hotline +49 5933 92467-247
Technical data EP 100
| Strapping | 4-Fold Horizontal 5-Fold Horizontal high-rise format 5-Fold Vertical 5-Fold Vertical + 3-Fold Horizontal |
| Press force | 80 Tons |
| Filling opening | 1.000 x 1.800 mm |
| Channel cross-section | 750 x 1.100 mm |
| Drive power | 22 - 2x45 kW |
| Bale weight | 500 - 700 |
| Bale length | up to 2,0 m |
| Length | 10.000 mm |
| Width | 2.580 mm |
| Height | 4.980 mm |
| Total weight | approx. 20 Tons |
Options
Piston-Slider
For closing the press plate during the pressing process so that no material enters the lance guide slots. Hydraulically driven closure plate mounted on the press plate.
This closes the needle slots during the press stroke. These needle slots are only opened during the strapping process.
This guarantees a wire-crack-free workflow and reduced cleaning and maintenance intervals.
Bottom-Slider
For closing the bottom during the pressing process so that no material gets into the lance guide slots. Hydraulically driven closure plate installed under the bottom wear plates.
This closes the needle slots in the press floor during the press stroke. These needle slots are only opened during the strapping process.
As a result, we guarantee a wire-crack-free workflow and low cleaning and maintenance intervals.
Prepress Flaps
Lateral two-part pre-compression flaps for effective pre-compression of difficult-to-cut materials.
Perforator
Perforator for perforating and squeezing PET bottles, retractable from the side or rear.
The perforator is equipped with two drums that rotate in reverse direction shortly after each other and are equipped with over 1000 spikes
The spikes are aligned so that the bottles are not trapped between them.
Ruffler
WEP whirler retractable from the rear on a console with a drive power of 22 kW.
This allows smooth surfaces, for example of catalogs, to be broken, so that better compaction is possible.
Hardox interior trim
10 mm thick inner lining of the entire bale chamber made of wear-resistant steel in bolted design.
Special equipment for artificial mineral fibres
Equipment package to equip the channel baler ready for approval for the compression of KMF (artificial mineral fibers).
The optimal equipment
With various additional features that allow adaptation to specific challenges, our channel balers with wire strapping in the HP series prove to be particularly versatile and versatile in use. As required, each baler can be equipped with, among other things, a fast-lift cylinder for energy savings or protected against wear and tear by full Hardox equipment. Remote control operation also facilitates work, with maximum security provided by the key transfer system fitted as standard. Our HP models are individually equipped to master demanding tasks in waste compaction in line with customer requirements.
Everything and more
With its technically advanced but easy-to-use additional functions, the HP series is excellently equipped for applications under difficult conditions or with specific targets that require, for example, variable strapping, a strong reduction in wear, or an analysis system for higher safety. Through individual consultation, we always find the right solutions for our customers that fully meet the requirements in waste compaction. As an alternative to the HP series, we provide our customers with the slim standard variant.
- Pressing force between 100 and 180 tons
- Stable construction of the base frame
- Height adjustability of the pressing shield
- Piston bottom closing plates
- Cardanic suspension of the main cylinder
Michael Brinkmann
Sales and Consulting
michael.brinkmann[at]europress-umwelttechnik.de
Tel.: +49 5933 92467-16