Ejector accelerator by KNARR available in smaller sizes

The ejector accelerator is considered a simple and worthwhile standard solution, especially for plastic parts that are difficult to demould. The rocker-like design of the component accelerates a single ejector pin so that it is almost impossible for the moulded part to get stuck in the mould..

Additional ejector stroke

The accelerator is installed directly in the ejector base plate, is optimized for plate thicknesses of 17 mm, 22 mm and 27 mm and allows a maximum of 7.6 mm additional ejector stroke.

Ejector package with or without washers

The ejector accelerators (Type 1) are available in several standard sizes and are suitable for ejector pins with the following diameters:

• NEW: 2.0 – 2.2 mm
• 3,0 – 3,2 mm
• 4,0 – 5,2 mm
• 6,0 – 8,2 mm

A Type 2 variant with a 4 mm increased height is also available for each size. This is used when washers are installed in the ejector set. Thanks to the coordinated height, no additional adjustment is necessary – installation is therefore quick and easy.

For more information visit: knarr.com